A Method for Plant Stress Detection by Online Ethylene Measurement in the Root Zone of Hydroponic Cultivated Plants
一种利用水稻栽培植物根区在线乙烯测定植物应力的方法
D. Brohma, N. Domurath, S. Faber and F.-G. Schröder
Faculty for Agriculture / Landscape Management
University of Applied Sciences Dresden
01326 Dresden Germany
Abstract
Detection of stressful situations of plants and crops presents a seductive possibility to discover harmful circumstances before a permanent damage or losses of
harvest appear. For this aim, a new portable ethylene measurement device was tested in a small glass chamber setup. Hybrids of Solenostemon scutellarioides were stressed by high salt concentrations applied with the nutrient solution and by injury of upper parts. Sample air was taken in the root zone. During salt stress a change of the normal periodic rhythm of the ethylene synthesis was noticed on all stressed plants. No reaction in ethylene synthesis was noticed in the root zone after injury stress.
检测到植物和作物的胁迫情况,可以在发生永久性损害或收获损失之前发现有害环境。为此,在一个小型玻璃室装置中测试了一种新的便携式乙烯测量装置。Solenostemon scutellarioides的杂交种受到高盐浓度营养液施用的和上部伤害的影响。在根区取样空气。在盐胁迫期间,在所有受胁迫的植物上注意到乙烯合成的正常周期节律的变化。在损伤应激后根区没有发现乙烯合成反应
Keywords: Solenostemon scutellarioides, painted nettle, salt stress, injury, ACC
To produce 100 % hydrocarbon free air, a zero-air total oxidation module from SylaTech GmbH was connected into the System. The operating temperature was set to
400 °C. The maximum ethylene concentration at the outlet was <0.001 ppm. Temperature and humidity inside the chambers were recorded by a LOG 32 data logger. Ethylene measurements were operated by an ETH-1010 analyser from Fluid Analytics, Inc by an intake of 200 ml sample air. The device was standardised with a calibration gas of 8 ppm C2H4 and 99.9992% N before every measurement period. The change of the different gas flows was done with a multiposition valve from VICI Valco Instruments Co. Inc.
为了生产100%无烃空气,Sylatech GmbH的零空气总氧化模块被连接到系统中。工作温度设定为400°C。出口处的最大乙烯浓度<0.001 ppm。室内的温度和湿度由log 32数据记录器记录。乙烯测量由来自Fluid Analytics公司的ETH-1010乙烯分析仪通过速率200 ml/mins样品空气进行操作。在每个测量周期之前,用8 ppm C2H4和99.9992%n的标定气体对装置进行标准化校准。不同气体流量的变化是VICI Valco Instruments Co. Inc多位置阀控制完成。
实验设置原理图

